The Curve pop-up menu, shown below, gives access to options that allow you to change the shape of the lines being drawn between feature points. The shape of the line feature is governed by existence of curve comma codes on points.
The Curve Segment option will add the curve comma code to the points at either end of a line feature segment. Please note that a single line feature segment cannot be curved unless at least one end has the curve tangent comma code. Without tangents, it takes at least three points to describe a curve.
The Curve Between option will add the curve comma code to the points between two indicated points on a line feature. As it is expected that curving will take place between the two points, the two indicated points will also have the curve comma code added.
The Curve All option will add the curve comma code to all the points of an indicated line feature. As it does this, it will also remove any tangent or discontinuity comma codes from the points.
![]() |
![]() |
|
|
Before Curve Fitting |
After Curve Between |
Before Discontinuity |
After Discontinuity |
The Curve Discontinuity option will add the curve discontinuity comma code to an indicated point on a line feature. A discontinuity is where two curves start at a common point but do not share a tangent through that point.
The Tangent Point option will add the curve tangent comma code to an indicated point on a line feature. In the example shown below, the two most northerly points have been indicated. This is one way in which you can create a single curved segment on a feature. The other way is by having one point with a tangent comma code and the other with a curve or discontinuity.
![]() |
![]() |
![]() |
After Tangent Point |
Before Straight Point |
After Straight Point |
The Tangent Segment option allows you to add a curve tangent comma code to the end points of a line feature segment. This is often all that is necessary to simulate the curved parts of the pedestrian refuges found on urban roads.
The Tangent Between option operates in the same way as the Curve Between option except that the indicated points will have tangent comma codes applied to them rather than the normal curve comma code. The points in between the indicated points will have the curve comma code applied.
The Straight Point option will remove all curve comma codes from an indicated point on a line feature. This means that if either of the segments using the indicated point were curved, they would become straight. In the example shown above, the curve was generated though the three north-westerly points. Removing the curve comma code from the most westerly nullifies any effect of the other two points.
The Straight Between option will remove all curve comma codes from those points between two indicated points. Any curve comma codes on the two indicate points will remain.
The Straight All option will remove all curve comma codes from the points of a line feature.
Comments
0 comments
Please sign in to leave a comment.